Ark Nova Pavillon with manual support

for Ark Nova (2021) Layer by Layer

Akitchiu

Free

View on MakerWorld 6 17 Added Jul 19, 25 | Updated Jul 29, 26 Support Akitchiu by Liking and Boosting their model.

Plan Your Print

About 69 g of filament From the designer's print profile

Print Profile 14h 56m 69 g PLA

What it takes

3 plates 14h 56m 69 g PLA

P1S, P1P, X1, A1, X1 Carbon, H2D, X1E, H2D Pro, H2S, P2S, H2C, X2D, A2L

Plate Details (3)

0.2 mm nozzle, all plates

Plate 1 · Test Print

34m 3 g PLA · 3 g

Plate 2 · 15 pieces

6h 45m 31 g PLA · 31 g

Plate 3 · 16 Pieces

7h 37m 35 g PLA · 35 g

Designer's Description

I think the pavilion from PatR is very beautiful, but unfortunately the columns broke during my test print. That's why I added manual supports at the critical points in Bambu Studio. In this way, all 16 pavilions could be printed cleanly. The print bed should be completely cooled before removing the parts, otherwise it may be difficult to remove the thin layers at the bottom.

Translated from German - show original

Ich finde den Pavillon von PatR sehr schön, aber bei meinem Testdruck sind die Säulen leider gebrochen. Deswegen habe ich in Bambu Studio manuelle Supports an den kritischen Stellen eingefügt. So konnten alle 16 Pavillons sauber gedruckt werden. Das Druckbett sollte vollständig abgekühlt werden bevor die Teile entfernt werden, weil es sonst schwierig werden könnte, die dünnen Schichten unten zu entfernen.

ark nova ark nova pavillon