Twilight Imperium 4 Overlay -Less filament/sleeves

I liked the great design of JudgeFredd but it wasn't perfect so I made some changes. My sleeves didn't fit and my Race/resource boards also didn't exactly fit right. If that's due to minor differences between Fantasy Flight printings I'm not sure.

I altered the following in this remix:

• Removed obsolete unnessecary material on the bottom parts.
• Made the card slots wider by trimming some edges, so sleeved cards will fit (Sleeve Kings in my case).
• Scaled the parts slightly so my paper/cardboard parts fit better. It was too tight for my taste and would damage it otherwise in the long run.
• I decided to leave the ‘Token_Bottom’ as it was, because the extra bottom support is needed for grabbing tokens and not damaging the cardboard in the long run.

Adjusted the following scales in Bambu Studio as seen in the attached .3mf file:

• Faction_Top_Left: X 100,55 %, Y 100,55 %
• Faction_Top_Right: X 100,55 %, Y 100,55 %
• Token Top without Text: X 100,50 %, Y 100,50 %
• Token_Bottom: X 100,50 %, Y 100,50 %
• Faction_Bottom_Left: X 100,55 %, Y 100,55 %
• Faction_Bottom_Right: X 100,55 %, Y 100,55 %

Faction_Top_Left and Faction_Top_Right should be connected together on a flat table beforehand. NOT on the overlay with a sheet in it or you risk damaging it.

The seperate .stl files are exported from my .3mf file and already correctly scaled!

I also printed this on a sticker plate so I got these cool colored star effects on my top prints!

Please post your makes and let me know in the comments what you think!

Boost Me Motivate me to make more cool stuff ;)