Spirit Island Tokens — Amateur Set (5 pieces)

Heads up: these are amateur, low-fidelity tokens made by a hobbyist learning OpenSCAD. They're functional replacements for the paper tokens that ship with Spirit Island, but they are NOT polished display-grade miniatures. Edges are chunky, silhouettes are simplified, and the art is rough.

If you're OK with that — here's a set of 5:

• Beast — coiled serpent on a round yellow pedestal
• Wilds — two small fern-frond spirals on a yellow-green rectangle
• Mountain — three-peak silhouette on a gray slab
• Strife — clenched fist on a blue rectangle
• Beasts/Paw — grizzly paw print on a brown rectangle

Each token is two STLs (base + accent) for AMS / dual-filament printing: assign two filaments per token in Bambu Studio and print flat.

The "main" .stl attached to this listing is a small title plaque; the actual token models are the 10 extra STLs labeled by token name.

• Recommended: PLA or PETG, 0.2 mm layer, 2-3 walls, 15% infill.
• Bed orientation: flat side down (bases have a 0.4 mm chamfer).
• No supports needed.
• Bambu Studio: import a base + accent pair, Assemble, then assign filament per sub-part. Repeat per token.

• Proportions are eyeballed, not traced from the official art.
• Accent layers are single-height (no embossing detail).
• The Strife fist and the Beasts/Paw are the weakest visually.
• These are fan-made; not affiliated with Greater Than Games.