Wavelength Pocket Board Game Thing

Required hardware:

• 3x M3 6mm bolt
• 1x M3 nyloc nut
• 2x M3 nut

Print instructions:

• Print all the segment files without removing them or moving the build plate. If you are using a skirt, make sure it is sufficiently far from the object so that it does not interfere with the previous segments (>10 mm).
• Print the wheel file over the top of the segment files. Please note that you will need to flip the part so that the reliefs for the segments face downwards. Make sure supports are off.

Assembly instructions:

• The nyloc nut press fits into the dial. You may need a dab of glue or shim the hole with some electrical tape or whatever you normally do if parts have a loose fit.