One Night Ultimate Werewolf - Card Sleeves

for One Night Ultimate Werewolf (2014) Layer by Layer

Andrew

Card & Tile Holders Free

View on MakerWorld 4 14 Added Jun 25, 25 | Updated Aug 11, 26 Support Andrew by Liking and Boosting their model.

Plan Your Print

About 299 g of filament From the designer's print profile

Print Profile (2) 0.2mm layer, 4 walls, 15% infill 13h 52m 299 g PLA

0.2mm layer, 4 walls, 15% infill

2 plates 13h 52m 299 g PLA

P1S, X1 Carbon, H2D, A1, P1P, X1, X1E, H2D Pro, H2S, P2S, H2C, X2D, A2L

Plate Details (2)

0.4 mm nozzle, all plates

Plate 1

3h 12m 90 g PLA · 83 g PLA · 7 g

Plate 2

10h 40m 209 g PLA · 118 g PLA · 91 g

0.2mm layer, open top no supports

1 plate 32m 11 g PLA

A1, H2D, P1S, X1 Carbon, H2D Pro, H2C, X1E, H2S, A1 mini, P2S, X1, P1P, X2D, A2L

printed in 0.2 with an A1 with AMS. No top so you can see the card if you turn it around. printed without supports.

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

32m 11 g PLA · 9 g PLA · 2 g

As sliced by the designer. Your printer, filament, and settings may change these numbers.

Designer's Description

Boost Me

Card sleeves for One Night Ultimate Werewolf

Unfortunately overtime the cards get worn and visible marks start appearing on the cards, unfortunately this means observant players can distinguish the type of card based on their unique wear marks.

These card sleeves have been designed with the intention of hiding the cards within the sleeve to prevent “cheating” by looking for these wear marks.

I have included an image of the werewolf on the front of the card sleeve for aesthetic purposes, this however creates a challenge to print.

Included are two print profiles:

1: Werewolves are printed face down onto the plate, producing a cleaning image (especially on a textured plate). This means that support material is required inside the sleeve which can be tricky to remove.

I found running a knife in-between the support material inside the sleeve to separate it from the model on both sides of the support, then using needle nose pliers to twist / push the support material works well. If you cause any split / cracks along the side of the sleeve this can be joined back using glue or a hot knife / soldering iron.

2: Werewolves sleeves are printed on edge, meaning no support material is required except for a brim at the bottom edge, this is the easier option requiring less post work, but takes a lot longer due to number of increased filament changes.

card sleeve card games