Othello inspired / Reversi game

Othello inspired game sometimes also called Reversi. board is 272x217mm, not going to print on MK3

I am know there are other boards out there, but I wanted one that also held the playing chips on the board and a way to keep them from getting lost when being stored.

You need to print 1 board and 64 chips and optional 2x covers if you want to store it and make sure the chips do not fall out. They should snap into place and are not too hard to remove.

If you want to print the board tiles separate print the alternate board (board for separate tiles) and 64 tiles, there is a test print to make sure it works on your printer, you may need to size the tile up or down, if too loose glue it.

There is also a 2 part chip, it should just press fit together, if they are too loose use some glue

Printing

I printed at 0.2mm layer height with PLA

The ones in the pictures I did a filament swap for the board at layer8 start 1.6mm and swapped back at layer 11 start 2.2mm The top of the tile is 2mm

for the chips I swapped color at 3mm height, total chip height is 6.1mm