Hanabi - Inlay and card holder

This is an Inlay for the game Hanabi . It fits the whole game and includes card holders for 5 Players (2 Holders for each Player).
It is designed to make the lid fit a lot better, so you could even pick it up at the lid.

I recommend printing the latch at a 45 degree angle and make sure the first layer lines go perpendicularly across the bending parts.

1. First bend the latch (also the wide end) 2. Slide it into the hole on the bottom 3. Make sure the end part is correctly fitted into the hole
Boost Me If you like this inlay