Critter Kitchen Insert and Organizer (with A la Carte Expansion) - DELUXE

**I should not have to add this to my posting.... DO NOT SELL MY WORK. My work is available for NON-COMMERCIAL USE ONLY. I make and upload inserts for free to give back to a community that has given so much to me. If you steal my stuff, I will make sure your site is taken down and you are banned.**

I received Critter Kitchen recently, and after the hour it took me to unbox and rebox it into the GameTrayz, I was annoyed and disappointed to find that there was between 5-10mm of lid lift. Upon investigation, it appeared that not only did the stacked player trays NOT nest together, but they had a very defined lean into the innards of the box, evident every time I tried to remove the trays from the box, which made getting the card tray even more annoying to get out (iykyk). So I fixed it. Given the sheer number of complaints I've seen about the trays being wonky for so many people, I hope others can benefit from my work!

You will need to print SEVEN of these with just ONE lid for the top. When you get them all into the box, you should have room for your empty bag, as well. I've also included boot-shaped box for the bag space in the bottom to hold all the ingredients!

EDIT 3/17 - The ingredient bag and tokens ended up cracking my card tray, so I created a new one that fits within the lids of the Zous Chef and Token boxes to replace it. I've uploaded it for your use. NOTE: I have the FULL file uploaded, and then I have a file that's been split into two for smaller printers.

EDIT 3/24 - (**FOR SLEEVE USERS**) Poster [Jon Skotniczny on BGG](https://boardgamegeek.com/thread/3478703/article/45827865#45827865) states the following: "I increased the size to X = 141 and Y 192 and this enlarged it enough to comfortably hold dragon sleeves in each slot."

UPDATE 3/28 - our friends on discord have upsized it by 104% and sleeved cards fit perfectly in the tray. You will need to put it under the token trays where the card tray originally was.

EDIT 3/28 - At the request of our friends on BGG, I've created and uploaded an alternative version of the card tray with finger holes installed and a slight raise under one side of the cards to accommodate the full token bag beneath the card tray in its original position. **This is an experimental build** and was printed and tested by our friend Ceiling Hawke on CA's discord, as they requested these adjustments. Ceiling Hawke then upsized it by 104% to accomodate their sleeved cards. Our thanks to our discord friends! (Yes, I will be adding finger holes to the original tray after I've finished my Apothebakery and Dark Quarter inserts.) These files are labeled "ALT" and "EXPERIMENTAL" to indicate the above. You may print the full version, but I've also split it into two files for smaller beds.

Enjoy! 💗