Folding Lap Board for Dice Throne (New Update)

This new version doesn't require any glue or hardware, fits sleeved cards (tested with Official Dice Throne Sleeves), and includes a card holder.

This foldable lap board was designed for use with the Dice Throne board game as it is intended to be lightweight and easier to store, while still fitting all of the components for the game.

**If not using the 3mf file, You will need to print 2 of all of the following pieces:**
Deck Flap
Hinge ATop
Hinge Bottom
Hinge Pin ATop
Hinge Pin Bottom
Lock ATop
Lock Bottom
Lock Pin

Assembly
You should be able to push the top and bottom board pieces together after carefully lining up the tabs, then you can squeeze the tabs together until you here them lock in place and they are level.

For the Hinges, ensure that the beveled edge of the hinge is facing the same direction as the beveled edges of the board, then you can press the pins into place.
Please Note You will need to slide the Lock Bottom pieces both onto the Middle Bottom Board BEFORE snapping the bottom hinges on.

The Deck Flaps should snap into place but may need additional pressure.

The same goes for the Card Holder.
**10/5/26:** I have completely remodeled this file if you need any of the older files please let me know as I have removed the original files and replaced them with the updated version!

9/4/26 Update: I added a top right card holder piece for the old design that fits sleeved cards and updated the flip up deck guards to fit sleeves as well. you would need to download the Deck Flap and Top RIght Sleeved if you simply want the update to the old file.