Cubosaurs insert

Insert for Cubosaurs boardgames with sleeved cards.

The logo on the sides is not very well rendered but I've done what I could with what I had.
the surface under the auction tiles is slightly slanted on one end to allow for an easy removal.

Beware if you use a very low infill rate: there could be issues to support the hemispheres. I recommend avoiding 5-10%.
Do not print the bottom layer if you want to spare material.

This insert is not supposed to be removed to play but I've nonetheless foreseen some access in opposite corners for a removal in case of breakage or to replace the day there will be an expansion (if any!).