Betrayal at House on the Hill Token

This is a token I created to mark rooms after a haunt begins that have special conditions, such as rooms that you can perform a ritual in. I printed it in PLA with a white base and a black symbol (12) and a black base with a white symbol (4), which should accommodate all scenarios. It is 15mm in diameter and 1.6mm in depth.

Printed on a Snapmaker Artisan using both 0.2 mm Hot Ends. My best results were with the following settings:

General

• Layer Height: 0.06mm
• Speed: Slow (20 mm/s)
• Model Structure: Medium
• Support: None
• Adhesion Type: Skirt

Custom

• Initial Layer Height: 0.2mm
• Line Width: 0.2mm
• Z Seam Alignment: Random

A single token took roughly 1.5 hours, while a batch run of 12 tokens took roughly 6.5 hours.