Arkham Horror LCG Card Tray (FFG sleeved)

for Arkham Horror: The Card Game (2026) Lift the Lid

Elizzyble

Inserts Free

View on Thingiverse 121 1,339 4,410 Added May 7, 19 Support Elizzyble by Liking and Boosting their model.

Remix of View the original model (Thingiverse)

Plan Your Print

✓ Fits sleeved cards

Designer's Description

Print these 2 times:

Token cap.stl
clue&resource tray.stl
Life&sanity tray.stl

Print as many as needed:

Deck divider.stl

**Optional:** If you also sleeve your mini investigator cards, only up to 3 will fit in Card_tray_with_mini_card_slot.stl. You either want to print 2 or only put up to 3 sleeved cards in the slot, and the others in between a couple decks between the posts. If you do not sleeve your investigator cards, all 5 should fit into the slot.

This was made without explicitly planning for any expansions.

This is my first board game box insert that I drafted up. As much as I really liked the simple card racks from https://www.thingiverse.com/thing:1906534 they did not fit Fantasy Flight Games grey pack card protectors. The largest pieces were also just big enough to not fit on my print bed. So I used Brahm's design design as a model for smaller card racks, then instead of having any space for miniatures or an *shudder* all mixed up token cup, I made small, segregated token holders to decrease set-up time. As I use an Android app to draw Chaos tokens, the small space on the side that I had left is only used to store the chaos tokens, not any additional bag. There's still a little bit of room if the fabric of a bag isn't too thick.