Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.
Log in to join the conversation.
Splendor Box
Card & Tile Holders
Free
Designer's Description
The original box is HUGE compared to the contents - so let's make more room on your shelf!
Contents:
There are two files provided:
- With Separators - contains built-in card separators
- No Separators - does not contain the built-in separators
The two files are identical save for the card separators.
Print one of each for a full build. Or print two of the same type - both work!
Print settings:
- 0.25mm layer height
- No supports or brim
- I used PLA
Additional components:
In addition to printing the provided model, you will need:
- 10x5x2mm (8) magnets
- CA glue (for gluing in the magnets)
- 1/8" metal rod (for the hinge)
I found that gluing in the magnets is easiest one half at a time. Once one side is dry, put the 4 magnets on their counterparts to ensure proper polarity, then glue them into the other side.
/pic8542875.jpg)
/pic8417466.png)
