LayerUp Stats 7
Add Jul 14, 26 Sync Sep 2, 26
Table Talk
Nothing here yet. Love this design? Say so - the designer might see it.

mini fig display stand

for Tabletop Accessories Layer by Layer
FIERCEWOLF
Miniatures Free
View on MakerWorld 255 505 Added Jan 4, 25 | Updated Sep 2, 26 Support FIERCEWOLF by Liking and Boosting their model.
Plan Your Print
About 160 g of filament From the designer's print profile
Print Profile 6h 6m 160 g PLA
What it takes
2 plates 6h 6m 160 g PLA
X1 Carbon, P1S, P1P, X1, X1E, A1, H2D, H2D Pro, H2S, P2S, H2C, X2D, A2L
Plate Details (2)
0.4 mm nozzle, all plates
Plate 1 · supports x 3
3h 26m 95 g PLA · 95 g
Plate 2 · minifig rails x5
2h 40m 65 g PLA · 65 g
Designer's Description

Boost Me YOU CAN DO IT ! ! !

This is my interpretation of a mini fig display stand allowing you to expand to as many as you wish. Each rail is very sturdy and you can stand or sit your minifigs on these rails. While this my not be a perfect fit/design for all minis, it will hold them firm enough to display them with out them falling off once seated.

NO glue necessary, rails slide into supports. rails will be very snug but if you slide it in and pull it out the next time you slide it in it should go in much easier, that or rotate rail and try it that again.

To add more rails simply position the rails half way on the supports and add rails and 2 extra supports adding as many as you want.

I would love to see your print! post a pic.

mini fig minifig minifigure figure stand display bricks brick bleacher