Tak - A Beautiful Game (Board)

I resized the storage game board by Tyler Mayer to fit 2x10 mm magnets.

Print Settings:

0.2mm balanced

Lightning infill (did this by mistake as my test pieces were done with lightning and I forgot to change it....turned out though)

Suggest smooth plate or adding brim. My first piece was on the satin sheet and the edges warped a bit.

Since I used marble pla and silk pla on a single extruder printer...I cheated and set it to two extruders and added an M600 for tool changes in the g-code so I could use my tuned filament profiles. If you are using the same filament between the two colors you can just do normal filament changes.

I only supported the storage area walls. There are 27 mm bridges under the model so tune your bridges! I suggest watching this youtube video:

Glue in 2x10 mm magnets on the finished model.

Pieces file found here: https://www.printables.com/model/1759751-tak-a-beautiful-game-pieces