Not Another Splendor Box!

Years ago I gave Splendor as a gift, and printed a box from Thingiverse because I had to fly internationally to gift it.

Last week, I wanted to do that again, couldn't choose from all of the options.

So, I decided to make the situation worse by redesigning my own case.

What's different about this one is

• I believe it is the absolutely smallest Splendor box ever made
• The lid prints in vase mode and attaches mechanically with a press fit

• The lid prints in vase mode. I used a 0.4 mm nozzle with extrusion width set to 0.6 mm
• Since it's a press fit, it's impossible to upload a model that will work for everyone's printer. Since it's a quick print and it's easy in today's slicers to rescale, if the model doesn't work out of the box, hopefully 1 or 2 iterations of rescaling will get you there

Lid should slide on tight and then click into place.

It's a little hard to remove. I've been holding the base through the cutouts when I pull the lid off to get it started. I assume it will loosen a little over time.