Fast Flowing Forest Fellers Insert/Organizer

The photos show utilization of Sunlu PLA Silk Blue. Designed in TinkerCAD.

One file to print for all pieces and is small enough to print on average printer bed but still large enough that it won't shift too much in box. It survived my box tilting and turning around, upside-down, etc.

I personally utilized at 205 degrees and 60 degrees. 0.3 mm at 70 mm/sec with 10% infill and a brim. I find this saves time.

I recommend waiting for it to cool completely before removing from bed after print or else you chance bending it.

Do not use concentric infill for this, for some reason it fails. Recommend Cubic or to check your layers in preview to make sure it will print properly (in my first print when I used Cura with 10 percent infill with concentric...in two spots it started filling in empty space which caused issues with filament going everywhere)