Elegant Stand for Figurine (No Support)

for Tabletop Accessories Layer by Layer

Livano

Miniatures Free

View on MakerWorld 332 546 Added Sep 11, 24 | Updated Sep 2, 26 Support Livano by Liking and Boosting their model.

Plan Your Print

About 22 g of filament From the designer's print profile

Print Profile 56m 22 g PLA

What it takes

1 plate 56m 22 g PLA

P1S, P1P, X1, X1 Carbon, X1E, A1, A1 mini, H2D, H2D Pro, H2S, P2S, H2C, X2D, A2L

No supports needed. No brim needed. I printed this stand on a P1S. 0.20mm standard @BBL X1C works fine. I set the Seam Position to ‘Back’, so they would all be gathered in one spot. I set Top Surface Pattern, Bottom Surface Pattern, and Internal Solid Infill Pattern to ‘Concentric’ to make the disks look nicer.

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

56m 22 g PLA · 22 g

Designer's Description

A small, elegant stand for whatever you want to display.

I own several seated figures (e.g. noodle stopper, relax time, perching figures) some of whom can't sit properly on a desk, so I made a stand for them to sit on.

To avoid potential issues with supports and overhangs I separated the stand in two pieces so your printer can simply print it widest-to-thinnest. The top and bottom part connect with a plug-and-hole system.

Dimensions of the assembled stand are 60x60x55mm, the base has a maximum diameter of 54mm. You can scale it up or down, but I have not tested the size limits of the design.

I set the print pattern to concentric to give the visible disk parts a nicer look.

Tip: The plug and hole are a tight fit, but they do fit. You may want to insert the plug in the hole and rotate several times for easier assembly and disassembly.

stand noodle stopper anime figure display decor miniature mini pillar column