Card Holders for Viticulture (Sleeved Mini Euro cards)

These card holders can be use for any game but I design them specifically for Viticulture with sleeved cards. The magnets inside keeps the tray in line on the playing board without too much force.

Magnets used were 10mm x 1mm from amazon.

Printing instruction:
When you slice you model, make sure to add a pause to drop your magnets if you decide to use some.
I tried printing them with PLA at 0.1mm and 0.2mm layer heights and both of them give good results. The 0.1mm gives you a smoother ramp but takes more time.

For viticulture:
The 40mm model is for the yellow and blue visitor cards.
The 28mm model is for the green, purple and orange cards.