Magnetic Frosthaven/Gloomhaven standees - Second Edition!

This is a complete rework of the "PERFECT Gloomhaven/Frosthaven Standee Set with MAGNETS". It is better in every way.

Main features:

• HP counter visible from both sides!
• Rounded edges of monster and conditions holder (should not scratch the surface of the cardboard).
• Monster slot in the center of the standee with space for two conditions (more are very rarely needed).
• HP counter 0-9 on the standee itself + magnetic 10hp tokens.
• Included 3mf files with correct layers for magnet insertions and for color changes.
• Compatible with Gloomhaven standee container (tight fit).
• Available in two modifications - low and high profile . See included files (the top part is the same).

Material needed:

• Printed with PLA, 0.2mm layer, 0.4mm nozzle, 15% honeycomb infill.
• Magnets used: 5x1.6mm (slightly smaller ones should work without issues). You need 1x for every standee and 2x for every 10hp token.

Print and assembly:

• Bottom part pauses for magnet insertion. All magnets need to have the same orientation!
• It is better to print the middle part using glue stick. Otherwise the inner legs did not stick properly for me. But your experience may vary.
• Middle part has a draft shield. For me, the numbers printed better if it went around the model first to print the shield layer (after filament change).
• Top part prints without issues. After printing all three parts of the standee, put a little drop of common cyanoacrylate glue in the hole at the base of the top part and assembly it together.
• The 10hp tokens have a color change and a pause for insertion of 2 magnets set in the 3mf file.