Tenby Insert/Gameplay Organizer(sleeves supported)

This is an Insert Tenby that can be used to help store your cards and help organize your plays. It supports sleeves but does not support the expansion that came with the crowdfunding campaign.

0.12mm layer with 7% infill

UPDATE: I updated the models to have similar features of the game to try an bring over some its charm.

My goals for this were to support sleeves and help organize the game since it can get unwieldy during play. I also wanted to make sure cards were not too tight of a fit so there is a bit of wiggle room. But considering the small box size, concessions had to me made. Most of the walls are 1.5 mm thick. I always use Rapid PLA+ so I am not sure how other filaments will do. It's a pretty light game so I don't see people having issues.

A few considerations when using this insert.

• All card storage has an open sides with most having multiple that face different directions. Putting cards in pulling them out can be a pit of a balancing act. You can also load and unload the cards so you can add and remove the insert without having to worry about that issue.
• The Resident Cars tray opening needs to face the same direction as the two trays besides it. The prevent cards from getting mixed up.
• Make sure all the cards being stored in the Pier discard tray are pushed in to avoid being damaged when sliding in the spacer.

Let me know if you have any issues

Enjoy!