Praga Capvt Regni board game insert

There are a few inserts out there for this game already - however, none of them serve my ultimate purpose - accommodate the church structures being permanently glued together. I don't like setting cardboard structures up over and over again with each game. So this insert solves that.

It also helps set up time tremendously, with the gold/grey/red tiles ready to put directly on the board, and an organized space for everything.

Everything goes into the box in a very specific order. I tried to capture that with my (poor) photography. Hopefully it makes sense.

The "Cath Bridge Pieces" are printed separately, and they "can" be push fit together, so that they fit nicely onto the bottom row of the structure, but I went ahead and glued mine together. The same can be said for the Player Pieces. You can either print out the three-piece-part system I created, and glue it all together, or you can print the "boring" single box solution that works fine too.

There is no lid lift, and everything is tightly fit enough that lids are not needed for the trays on the upper level. The only required lid is for the "Egg Holder" box, due to the fact that the empty bridge rests above it, which would cause the eggs to fall out. When I printed the "Egg Holder Lid" I turned off the top and bottom walls so that it would print in a see through cross pattern. Such is not required. If you find the lid too tight, you can always lower the overall length and width by .1 or .2 if needed.