Orloj Insert

This is remixed from karnick's great design on Makerworld (https://makerworld.com/en/models/2016404-orloj-insert-boardgame). I liked most of what he did, but I wanted to make a few changes:
- I trimmed out some areas to reduce filament without compromising on the design
- I amended the card storage so that it held all cards while sleeves (there was not enough room for the premium thickness otherwise)
- I prefer having one large holder for the resources, so merged these. If you prefer two smaller then his original files will still work for these
- I don't like using lids so I amended the heights so that other trays and the board act as the lids to hold things in place

I can confirm it now fully supports premium sleeves and vertical storage.

Cards are separated as follows:
- Workshop cards in open top deck holder for placement by the board
- Sectional deck holder splits them into starting/setup cards, solo setup cards (small middle section), and solo action cards.

Print 4 of the player file, and one of everything else.

My print in the photos is hashed as I print without tops/bottoms/walls to save on filament.