Clans of Caledonia Insert/Organizer

Clans of Caledonia Insert/Organizer

If you're going to store this one flat, you probably don't need to print all the various spacers (especially the 2 and 3 step spacers). You may not need to print them all out if you store it vertically. *shrug* I was trying to make it all nice and full and flat. As always, some of this design is as much learning as anything else.

With everything printed, it MOSTLY passes a shake test. If you look in the photos, you might see a coin that's out of place. Short of creating spacers that EXACTLY fit the hex boards (I'm not going to) or adding lids (I prefer not to), I'm not sure how to avoid that.

I dumped a bunch of stuff in the "miscellaneous" box, but you could easily divvy it out, should you prefer to. There's plenty of space to organize it differently than I did. (You just might end up with box sides being unlabeled/mislabeled.)

Assuming you print the entire insert, you will need one of each file apart from the following:
Print 4 of PlayerX4
Print 2 each of 3StepSpacerX2, ContractsX2, and ResourcesX2.stl