Terracotta Army Insert/Organizer

Simple insert for Terracotta Army to go along with the already existing Warrior organizer that comes in the box.

FigsA.stl sits on top of the Horses.stl. With the Horse figures in place, the horse heads slightly overlap the figures piece -- so I just remove them both at the same time. (You could flip around the figures insert, but then they risk sliding out.)

Pieces should be oriented to print easily without any supports, but just in case, make certain that the base slots for FigsA, FigsB, and Horses all point upward.

Otherwise, honestly, I think this one is pretty straightforward, but feel free to leave any comments below.

Number of copies of each item are baked into the filename as _x#.