Storage Insert compatible with Space Hulk, for normal sized printers

What changed: The original has some pieces up to 279mm. This version splits pieces to be able to fit on smaller print beds like the Prusa Mk3 and Mk4. I think of the insert as 4 main sections, each with sub-parts. The 4 main sections are tiles_deep, tiles_shallow, figures_deep and figures_shallow. In the pictures I included, I have tiles_deep on the left side with figures_shallow on top of it, and tiles_shallow on the right side with figures_deep on top. For each of figures_shallow and figures_deep, you can print either the original more open version intended for magnetized miniatures, or you can print the compartmentalized version with an individual compartment for each miniature. So if you are printing for magnetized miniatures you would want to print: - spacehulk_figures_shallow_split_a - spacehulk_figures_shallow_split_b - spacehulk_figures_deep_split_a - spacehulk_figures_deep_split_b (optionally print 2 further split parts) - spacehulk_tiles_deep_v2_split_a - spacehulk_tiles_deep_v2_split_b - spacehulk_tiles_shallow_split_a - spacehulk_tiles_shallow_split_b (optionally print 2 further split parts) - spacehulk_command_points_split (this is basically tiles_shallow_split_c) - spacehulk_door_bases (fits inside figures_deep_split_b, unnecessary if you use the further split option) - spacehulk_holes (fits in tiles_deep_split_b) - spacehulk_blips_v2 (fits in tiles_deep_split_a) If you are printing for compartmentalized miniatures, swap out the 4 “figures” parts for: - spacehulk_figures_shallow_compartments_split_a - spacehulk_figures_shallow_compartments_split_b - spacehulk_figures_deep_compartments_split_a - spacehulk_figures_deep_compartments_split_b For at least some of the 4th edition release, it seems GW included a significantly larger sand timer (3cm diameter instead of spacehulk_blips_v3 (fits in tiles_deep_split_b) INSTEAD of spacehulk_holes AND spacehulk_blips_v2.