20 Strong Insert

There are two versions of this, one with the 20 strong logo inset on top and one without. Printed with supports, 0.3 layer height.

This fits into the core box along with one of the decks of cards.

Each slot for the dice is meant to hold each different strength, then the last slot is for the red/3 other dice. The v2 dice slots should be 0.5mm larger than the dice and should work smoothly

The core rulebook slots into the long opening, with finder holes to remove it and the insert from the bottom of the box.

Also, by request, I've made a psuedo “deck box” modification to the insert. This will allow any of the decks to slot into the insert (without the deck box), giving you a fully contained solution. Just slide a deck into the insert but it in the box and go! Please note: this version is not yet tested (since my printer decided it needed another new hotend to function….), so print at your own risk. It is measured to fit the hoplo deck and should have no lid lift. If you print this one, let me know how it works!

New version 3 added. (These have an extra mm of space in the deck area. as well as a larger thumb notch cutout for the cards.) (Also note the logo version is very thin to accommodate the logo. Let me know how it turns out if you decide to print it!

Any tips (@ajops pp/venmo) / feedback welcome