Card holder

This card holder is a bit bigger than my previous creation, but it's still much smaller than average size modern smartphone so it should fit to every pocket, it also doesn't have sharp edges exposed. Unlike my previous card holder this thing has an actual mechanism, it's very simple so in theory everybody should be able to assemble it without any issues... yeah, in theory. To make it work you need at least 1 small rubber band that you should put in the place shown on the photo. This is where the fun beggins, now you can put even smaller rubber band between two latches, you should notice where to attach the band. If it slipps off, you can glue it into place but make sure that band is thin enough it doesn't colide with the top part. I believe I don't have to explain whole assemblin process so I'll give last advice, use super glue to connect parts. If you can't find thin enough rubber band to put in between the latches, you can use CUT parts, they don't allow you to put the second band but they make cards easier to take out.