Round 2 Piece Magnetic Cribbage Board

This is a blank slate of my cribbage board I designed. There are two pieces, a top and bottom and they are held together magnetically by embedded magnets. This was designed to be printed on a Bambu labs with AMS and to be highly configurable as to color schemes. As such there are a ton of bodies to go through when colorizing but I tried to make the naming convention somewhat intuitive.

***Print Settings***

.16mm Layer Height, 3 Walls, 4 Top Shells, 4 Bottom Shells. Gyroid Infill @ 20%. No supports, No brims, No Prime Tower. For the Top Plate print with the holes down facing the build plate and insert a pause at layer 82 (In Bambu slicer after you slice the file; go to the preview screen and adjust the slider on the right to the layer indicated and then right click and select insert pause). For the bottom plate, print face up and insert a pause at layer 176.

*** Magnets ***

You will need 8 total magnets that are 32mmX3mm in size. If you insert pauses where indicated above then the machine will stop and wait for you to insert your magnets in the provided spots. Pay attention to the polarity and make sure they are all the same way. My recommendation is using a dab of superglue on each and letting it sit for a while before resuming. You CAN do it without the superglue but these magnets are pretty strong and make lift to your hot end when its over it. Once the machine lays down a few lines over the magnets you are good to go.

Any questions let me know. I left the main areas blank so you can customize with artwork as you see fit.