Skip-Bo box for sleeved cards

Designed to hold one Skip‑Bo card set with plastic sleeves. There are indentations on the inner walls, so the game manual will also fit inside the box. There are holes at the bottom and at the end of each section, which, in my opinion, make removing the cards from the box very easy.

The case is fairly loose inside, so it slides out easily. To prevent this, I added a separate latch that secures the box when it tries to slide out. I printed both the box and the case in PETG, and I also tried printing the latch in PETG. The latch performed surprisingly well with PETG, although it shouldn’t be overly smooth. The final latch was printed in TPU, but I had to scale the model up to 110 % for it to hold properly.

Update: I made version 2 of the case. Walls are a quarter thinner and inside width is smaller, so there's no room for the latch.