Gaslands Gear Phase Billboard

This Gear Phase indicator is a Remix from Sablebadgers Billboard. This FDM printer friendly set piece for Gaslands integrates your Gear Phase into the play field.

This was designed to use a length of filament as the hinge pin. If there is an issue inserting the filament all the way across, insert one piece of filament from the one side but only half way. Repeat for opposite side.

The number flags are made to stop perpendicular to the back of the billboard. If you prefer to have the number flags flip all the way down, carefully sand/file the bottom edge of each flags hinge to allow clearance.

As a reference, I have listed the settings I used for this print below. Run your printer on your own optimized settings if you know them. Print orientations as follows. Stand: upright. Billboard: on back with hinges touching bed(Supported). Number Flags: on long edge(Supported). If bed adhesion is an issue with these orientations try to utilize brims.

My Print Setup
Printer: Ender 3 V2(factory firmware and hardware)
Filament: e-Sun PLA+(white)
Nozzle: 0.4
Slicer: Cura
Layer Height: 0.12mm
Wall Line Count: 3
Top/Bottom Layer Count: 4
Infill Density: 25%
Infill Pattern: Lines
Printing Temp: 224c
Bed Temp: 63c
Support: Yes
Support Density: 15%
Support Interface Density: 40%