Parks Second Edition CARD HOLDERS

for Parks (Second Edition) (2025) Lift the Lid

TheVillas

Card & Tile Holders Free

View on MakerWorld 1 Added Sep 28, 26 Support TheVillas by Liking and Boosting their model.

Also Found On Printables

Plan Your Print

✓ Fits sleeved cards

✓ Fits premium sleeves

About 33 g of filament

Print Profile (2) Parks - no texture card holders 1h 4m 33 g PLA

Parks - no texture card holders

1 plate 1h 4m 33 g PLA

P1S, X1, A1, X2D, X1E, P2S, A1 mini, H2D, A2L, H2C, X1 Carbon, H2D Pro, H2S, P1P

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

1h 4m 33 g PLA · 33 g

Parks - wooden textured card holders

1 plate 1h 16m 32 g PLA

P1S, X1, A1, X2D, X1E, P2S, A1 mini, H2D, A2L, H2C, X1 Carbon, H2D Pro, H2S, P1P

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

1h 16m 32 g PLA · 32 g

As sliced by the designer. Your printer, filament, and settings may change these numbers.

Designer's Description

These are card holders for Parks (Second Edition), specifically made to hold sleeved cards.

Now, I recommend using standard sleeves (around 50microns) since premium ones are too thick (around 90microns), specially for the Park Cards. The smaller ones can handle premium sleeves but the fit is tight in the Solo Cards holder.

The ones used here are:

Park Cards: Steel Armour - Tarot 122x72mm (standard, 50microns)
Gear, Solo and Passion Cards: Steel Armour - Glory 52x77mm (premium, 90microns)

You can see they fit nicely in the designated compartments. Note that the ParkCards exceed its height by a few millimeters (shown in pics) which translates in a minimal lid lift if stored as shown (also shown in pics).

Two versions available: a wodeen textured one and a simple one. Choose whichever you like.

As for components, there is a holder for each deck (Parks, Gear, Passion cards) and a combined holder for cards used in Solo Mode (Ranger Teddy and Volunteer Project cards).

parks secondedition parkssecondedition boardgame accessories cardholder sleeved card sleeved