Button Shy Box v2, Single color and Multicolor

EDIT: If you downloaded the first day it looks like some of the files may have been corrupted. All new files below! Please comment or send me a message if you run into any problems!

_________________

This is a reworking of my small card box with decorations for my favorite two Button Shy Games. There is also a plain version you can remix yourself! The only difference between this and the previous version is I made the overall profile rectangular and added a bit to the front bottom to achieve that.

Includes a box for games Tussie Mussie and Sprawlopolis.

Warning: the two color versions waste a TON of filament and take like 12+ hours on a Bambu. But I think they look pretty fun. It was mostly just a fun experiment.

Needs two 6x2 magnets for the closing mechanism.

Multicolor printing: In your slicer right click the object and select Split>to parts . Select the colors for printing. PRO TIP: first make the entire object the color of the design and then you only have to change the color of the main piece instead of every small piece.

ASSEMBLY: Slide a piece of filament through the hinge leaving about 1-2mm of excess on each side. Use a flame/heat source to warm the end (1-2seconds max) and then press the hot plastic against a flat surface, locking the hinge into place. Glue in magnets, use my Magic Magnet Tool to get the polarity correct.

______________________________

Check out my other board gaming designs here on Printables!

I have other board game designs available at my Etsy shop Taylor Jane Design Co .