Spirit Island Token Holder

Esmerel on Thingaverse ( https://www.thingiverse.com/esmerel/designs ) created tokens for Spirit Island. They are great and are designed to switch filament on layers to print in multiple colors. I remixed each of these and made them smooth and printable with AMS. ( https://makerworld.com/en/models/1288061-remix-of-esmerel-s-spirit-island-tokens-for-ams#profileId-1317678 ) But, then I ended up with 370 tokens and no way to store and organize them. So, I designed this.

This is a tray that has openings to hold 37 tubes. The tubes were designed to hold 10 tokens each and have a lid that holds on with friction. Then that tube goes into the tray and a quarter turn locks it in place. The result is a tray that holds them all and they do not fall out if the tray is turned upside down.

Because 37 is a prime number, there was no good way to evenly divide these, so I added a middle column with one tube opening for a token tube and then added 5 larger openings to hold multi-color defense and isolate tokens (3 of each). They operate the same as the token tubes.

If you'd like to add labels to know which spirit goes where, I added an overlay to my project with all of the tokens that you can print either punched or AMS. (It requires a 0.2 mm nozzle, so I added it to the token project, which also requires (or at least looks better with) a 0.2 mm nozzle.

I've attached a pdf below showing each of the tokens and the order for them