Game Organizer Compatible with Ultimate Werewolf

This is a two-part design intended to replace the small, travel-sized box for Ultimate Werewolf featuring:
- Rigid and robust design
- Additional slot to house the instruction sheet (see pictures)
- Impression for original game box to be cut and glued into (see pictures)
- Printing tolerances included for fit

Once printed, the fit will be tight, slide the parts together and apart a few times to loosen it up. If fit issues persist, try reviewing the recommended print settings.

Printing Instructions:
0.2mm layer height
2mm wall thickness
Support on any ledge greater than 80deg 10% infil
I used gyroid infil at 10%
Brim adhesion
Print Lid.stl with the instruction sheet slot facing up (no support needed)
Print Box.stl with the card opening facing upwards (support needed)

This content is not official Ultimate Werewolf content.