Imperial Miners Accessories

I made a few additional accessories to go along Rayos ' box organizer/insert with here .

Designed in Fusion360. Everything is made to print at .2mm resolution, though the coins are probably the only things that care.

Card divider: Print two. Separates your level IV and event cards from the rest. Settings: just print it.

Board spacer: Print two. I considered designing without a bottom, but everyone likes more storage! Stack your cardboard components in two stacks over the other organizers, and put these on the side. Or however you see fit. Tetris mode: easy. Settings: also just print it.

Coins: I included three different sets. Modeled off of Portal's coins.

• Without numbers: print in different colors.
• With raised numbers: print at .2mm, set a color change at the last layer. Numbers on one side. I added a border so you can stack your shinies.
• With flush numbers: if you have a MMU, or like to trick your printer into thinking you do, here ya go. Numbers on both sides.

Reach out if you have any questions, or if you're looking for any other accessory upgrades.