Kingdom Death: Monster Hunt Board Replacement

This replaces the giant span of card board that is the Hunt Even Board with a smaller, more compact, and more reusable version.

Print this at .2 layer height, otherwise you'll need to recalculate the layer pauses.

The Hunt Board requires a pause at the start of layer 13 to insert washers (10mm radius, no thicker than 1.4 mm)

The tokens require a pause at the start of layer 15 to insert magnets (6mm by 1.5mm).

I got a bit high on my own supply with the hunt board holder. It will display the hunt board vertically and hold all the tokens.

The washer spacing gives the board a nice snappiness to it. I set all the tokens to the left hand side of the board and as we move down, I slide them to the right after resolving the event. This means if you're hunting the same level monster back to back you can just slide the tokens back to their starting points and you're good to go.

Tokens:

S - Survivors

M- Monsters

BH - Basic Hunt Event

MH - Monster Hunt Event

MG - Mineral Gathering

HG - Herb Gathering

SP - Special (catch all for the weird ones)

I painted my board cause I was bored, but it does help the legibility of the text. Eventually I'll paint the tokens as well.

Additional files provided to allow for magents/washers to be added post printed. "Bored through" models have holes on the underside to insert magnet/washers.