War Chest ALL IN (except Tournament Kit) Insert

If you want, you can help me with designing inserts by donating here:

or joining my club here:
https://www.printables.com/@Sortirus_659392#join.@Sortirus_659392.1094

Hello,

for those that don't know my ‘insert philosophy’ - I am creating modular inserts that are focused on reducing setup and space on table, filament consumption is not my highest priority, but of course I'm trying to save some material where I can.

• My prints take a lot of time to print. Why? First of all, to save filament, electricity price is much lower than filament price (at least in my country). Second of all - total weight, if it's to high it can damage the box and our spines :D + weight also influence vertical storage, box can open by itself,
• Clearence for holder covers is very small - 0.2mm horizontal, make sure that you have calibrated printer. In worst case - you could add like 0.2-0.4mm to cover width in the slicer,
• It doesn't support tournament kit, but there is a bit of space left, so you should be able to store components in the box (loose).

• vertical storage ,
• sleeves - it supports up to 70 microns,
• Nightfall expansion,
• Siege expansion,
• Nobility expansion,
• GeekUp bits? - I left a lot of space for them, but I'm not 100% sure if they will fit.

• Chip_Holder_x2 - for all unit chips,
• Chip_Holder_Cover - only 1 is necessary, but not required if you want to store the box horizontally
• Cards_Chips_Tokens_Holder + cover- for all cards, non-unit chips and tokens. Should support geekup bits, but I'm not 100% sure.

• about 400g (depends on your settings, I printed with 15% gyroid infill, 2 walls, 5 top and 3 bottom layers),
• at least 176mm x 158mm print bed.

Supports - no supports required.

• every file ended with xX (for example x16) - print X times (in given example - 16 times),
• if you have campaign sleeves - print __campaign_sleves version of corresponding model.

• I will update the insert if/when expansion comes out. It will be a full redesign.

Enjoy!