Crokinole 20s holder - 8 buttons

for Crokinole (1876) Layer by Layer

acenine

Scoring & Tracking Free

View on MakerWorld 15 93 Added Sep 3, 25 | Updated Aug 1, 26 Support acenine by Liking and Boosting their model.

Plan Your Print

About 29 g of filament From the designer's print profile

Print Profile (2) 0.2mm layer, 3 walls, 12% infill 1h 48m 29 g PLA

0.2mm layer, 3 walls, 12% infill

1 plate 1h 48m 29 g PLA

X1 Carbon, H2D, P1P, H2S, H2D Pro, A1 mini, X1, P1S, X1E, A1, P2S, H2C, X2D, A2L

• no supports needed • the seams are random • I suggest keeping the brim to avoid print failure

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

1h 48m 29 g PLA · 29 g

7.5mm rim version

1 plate 1h 29m 31 g PLA

X1 Carbon, X1E, A1, P2S, A1 mini, P1P, X1, H2D Pro, H2C, P1S, X2D, H2D, H2S, A2L

This is the same model adjusted to fit a 7.5mm/0.3in rim.

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

1h 29m 31 g PLA · 31 g

As sliced by the designer. Your printer, filament, and settings may change these numbers.

Designer's Description

This is a 20s holder for Crokinole.

Holds up to 8 buttons with diameter of 1.25in (32mm) and width of 0.38in (9.75mm).

Modeled to fit onto round board rim (30.25 in diameter and 0.25in rim thickness), but can also sit flat on the table.

There is a ridge on the bottom inside so that the buttons don't stick in the tube.

The cut out on the bottom that fits on the board rim is slightly curved, and it's sometimes difficult to tell which way it curves. I added an arrow to the bottom, just make sure that is pointing toward the center of the board and you should be good to go.

You can also check out my buttons holder:

crokinole buttons button disk disc chip 20s holder column tube