Deep Madness Investigator Card Holder

A card holder and dashboard for the investigator cards and related tokens/equipment cards for the board game deep madness.

Contains:
- Space for Investigator card
- Spinner to keep track of health
- Slot for drowning dial
- Slots for both sanity and madness tokens
- Space on ledge for other tokens
- Slots for stands so it can be used flat, at 30 degrees or at 60 degrees

Front panel can be printed in the 6 colours to match the coloured bases supplied with the game.


BOM (per stand):
- 1x 8mm M3 Screw
- 1x M3 Brass knurled nut ( https://www.banggood.com/100pcs-M3x5x5mm-Metric-Threaded-Brass-Knurl-Round-Insert-Nuts-p-1050182.html?rmmds=myorder&cur_warehouse=CN )
- 1x M3 Washer


Assembly:
- Glue the front and middle parts together.
- Insert the knurled nut into the hole using a soldering iron.
- Affix the spinner using the M3 screw, suing the washer as a spacer. Don't over tighten, just enough to give a bit of resistance while spinning and to hold in place. A small amount of glue can be useful to keep the screw in place.
- Glue the rear part onto the assembly.

CHANGE-LOG
29/11/2018 - Updated the spinner to be more optimised for printing with a 0.4mm nozzle. New file uploaded. Ensure extrusion width for top layer is 0.4mm.

18/02/2018 - Added a Mk2 variant to the spinner that utilises the dual colour, single nozzle technique Devan from Make Anything showed on his YouTube channel: https://www.youtube.com/watch?v=KV2AjyowXX4&t=1003s

This variant doesn't have a spacer on it so will require a washer or similar to be used as a spacer.

17/11/2019 - Uploaded assembly instructions with images in pdf format. Uploaded amended front and middle panels that give more room for sleeved cards.