Quacks All In Edition Insert / Organizer

If you want, you can help me with designing inserts by donating here:

Hello,

for those that don't know my ‘insert philosophy’ - I am creating modular inserts that are focused on reducing setup and space on table, filament consumption is not my highest priority, but of course I'm trying to save some material where I can.

• If you want to acquire commercial licence for this model, visit my club page on printables,
• my inserts are without lid lift unless I specifcally state otherwise,
• Clearence for holder covers is very small - 0.2mm horizontal. Please print the smallest holder and cover for it to check if it fits, if not you may need to calibrate printer or enlarge cover a bit (adding 0.2-0.4mm to the width in the slicer should be enough).

• vertical storage ,
• sleeves - 70 microns

• 5x ingridients holders - 5 holders for 9 ingridients + rubies,
• cards holder - for fortune cards,
• setup holder - for other cards, patients, witches and other tokens (unfortunately I'm missing some tokens, like witch pennies, but they're going into setup holder),
• player related components are stored in player bags.

• about 566g filament needed, (depends on your settings, I printed with 12% gyroid infill, 2 walls, 4 top and 3 bottom layers, 0.42 line width),
• at least 245mm x 128mm print bed (226 x 226 if you rotate ingridients holder).

Supports - no supports required.

• every file ended with xX (for example x16) - print X times (in given example - 16 times),
• refer to pictures how to organize the box.

• I think this insert is done.

Enjoy!