Blackout: Hong Kong – Board Game Organizer / Insert (3D Printable STL)

This 3D printable organizer is designed for **Blackout: Hong Kong** (Pfister classic) and is built to fit *inside the original cardboard insert* that comes with the game. The layout was designed around the **first edition**, but I believe it should also work for the **second edition** as well. Everything fits snugly in the box with a clean, secure pack and no component shifting.

The insert’s biggest quality-of-life improvement is the **Scout Tiles system**: all scout tiles are stored pre-sorted in **16 small trays**, each holding **3 tiles** (48 total), letting you set up the scout tiles in seconds and get playing immediately.

Cards can be stored **sleeved**, and trays include lids where needed to keep everything tight and organized.

This insert follows a *minimalist, no-waste design philosophy*. Every wall, divider, lid, and cutout exists for function—no decorative elements, no wasted material. The focus is fast prints, low filament consumption, and practical storage that speeds up setup/teardown.

- Designed for **Blackout: Hong Kong** and fits inside the *original box insert*
- Built around the **1st edition**, and should also fit the **2nd edition**
- **Scout Tiles “ready-to-play” system**: 16 trays × 3 tiles each (48 total)
- Dedicated storage for player pieces, money, starting cards, main cards, and tokens
- **Card storage supports sleeved cards**
- Lidded boxes where needed to prevent shifting and mixing
- Modular components make setup and teardown quick and clean
- Support-free geometry optimized for FDM printing
- Snug packing designed to reduce movement when stored vertically

- Includes a dedicated Scout Tiles Box and Lid
- Includes **16 individual Scout Tiles Trays**
- Each tray holds **3 scout tiles**
- Total capacity: **48 scout tiles**
- During setup, simply remove the 16 trays and place them on the table—no sorting, no rummaging

- Layer Height: 0.20 mm (Standard Quality)
- Infill: 15% (Grid or Gyroid recommended)
- Walls/Perimeters: 2–3
- Supports: Not required
- Material: PLA recommended
- Bed Adhesion: None, or brim if needed
- Orientation: Flat on the base

- Cards x1
- Starting Cards x1
- Money Tray x1
- Money Tray Lid x1
- Player Pieces x4
- Player Pieces Lid x4
- Scout Tiles Box x1
- Scout Tiles Box Lid x1
- Scout Tiles Tray x16
- Tokens Tray x1 (GPS, dice) x1

- 1× Cards Tray
- 1× Starting Cards Tray
- 1× Money Tray
- 1× Money Tray Lid
- 4× Player Pieces Boxes
- 4× Player Pieces Lids
- 1× Scout Tiles Box
- 1× Scout Tiles Box Lid
- 16× Scout Tiles Trays
- 1× Tokens Tray (GPS, dice)

This organizer is all about *speed and flow*. The scout tile system is the star: you store the tiles once, and every future setup is basically instant. Player pieces remain separated, money stays contained with a lid, and the card trays keep decks tidy (even sleeved). Everything fits snugly inside the factory insert for a clean pack and easy storage.

This listing is for **digital 3D model files (STL)** only. **No physical items or printed inserts will be shipped.** You are responsible for printing the files yourself or through a third-party printing service.

This organizer is an independent, fan-made project created out of appreciation for Blackout: Hong Kong. It is *not affiliated with, endorsed by, or sponsored by* the publisher, designers, or rights holders. All game names and trademarks remain the property of their respective owners.