Göteborg tram M29 for Ticket to Ride

I drew this model on top of the technical drawing I could get from the municipality of Gothenburg, then shortened it (removing a couple of windows) to make it fit the footprint for Ticket to Ride.

The M29 is still, according to me, the “correct” tram in Gothenburg, probably because it's the one I rode the most upon moving here.

This was made before receiving my box of Ticket to Ride - Göteborg. I haven't tested it yet! Please post a make if you try it out, so anybody can see if it fits.

Printed with 0.15 mm layer height, and variable layer height at the top to smoothen the roof (see last picture).

Recommended filament changes:
- 3.80 mm (to white)
- 7.85 mm (back to player color)
- 9.24 mm (grey for pantograph and air inlet)

Also check out DrK's model based on M31 , as well as Perandersin's based on M25 .

Source file in Onshape .