Vestige Sleeved Card Box Inserts and Trays

I really liked the insert by BoardGameMeta and even though I still used their trays for the various tokens, I didn't like that I couldn't use the rest of it with sleeved cards, at least the trays anyways. Unfortunately like most people on makerworld, BoardGameMeta does not allow remixing so I designed these from scratch.

These replace the bottoms for the card boxes and reuse the tops as covers so they will fit back in the box like they were originally intend to. I included slots in the dividers of the inserts to still be able to use the card dividers as well. Even if you don't print these in different colors, they each have the name of the cards that they hold on them.

I sleeved these in Sleeve Kings and most of the boxes still have a good bit of room so most sleeves will work. I'm not sure if the ones that Orange Nebula sold though are too long or not as I didn't order them so you may want to test out on the smaller "Setup" or "End Games" tray first.

The holes on the trays are there to make them easier to remove, just put a finger in one and a thumb on the corner of the tray and they lift straight up and out easily. I usually just use my middle finger and thumb for the box and index to hold against the cards and I can easily and quickly take them out one handed.

There is some variability in how you place the dividers for some of the slots but I set mine up like this from left to right:

Storage A

• Setup
• End Game Conditions
• Mercenaries
• Law Makers
• Smugglers
• Bounties
• Artifacts
• Augmentations

Storage B

• Chop Bots
• Covert Ops
• Treachery
• Nemesis (Against back wall with all four in front of it)

I printed these all in standard 0.2mm layer height on a 0.4mm nozzle.

Hope this works for you guys! Let me know if the O-Neb sleeves don't fit. Not sure I have the room to make them fit if not but it's a possibility if it's only a little.

Edit 7/24/2026: After being informed that the O-Neb sleeves do not fit I added a test print of the smugglers card tray to see if it will work with the O-Neb sleeves. I will edit the rest in a separate file after confirming if this one works.

Edit 7/25/2026: After confirming that the test for the edited smugglers tray fit the O-Neb sleeves I have uploaded a separate folder for both the O-Neb sleeves and the Sleeve Kings sleeves. I prefer the Sleeve Kings for my own because the short walls are a little thicker to match the long sides but the slightly thinner trays for the O-Neb sleeves should be perfectly adequate for them barring any irregularities in their sleeve production. Cheers!