Paleo card organiser

for Paleo (2020) Layer by Layer

Organizers Free

Also Found On Printables 10

Plan Your Print

✓ Fits sleeved cards

About 180 g of filament From the designer's print profile

Print Profile 4h 44m 180 g PLA

What it takes

1 plate 4h 44m 180 g PLA

A1, P1S, P1P, X1 Carbon, X1E, X1, A1 mini, H2D, H2D Pro, H2S, P2S, H2C, X2D, A2L

• Arachne wall generation to help detail on the lettering and strengthen thin walls. Switch back to classic if you have issues.

Plate Details (1)

0.4 mm nozzle, all plates

Plate 1

4h 44m 180 g PLA · 180 g

Designer's Description

Card Organiser for Paleo.

Remix Changes:

Has been remixed for sleeved cards.
I used “Gamegenic Board-Game Sleeves - Green” these measure 59 x 91mm
Only includes the base set of cards (no expansions)
Includes sets 1 - 5 and A - J
Card organiser base measures 160 x 105mm
Internal dividing walls have been made slightly thicker for improved strength.
Note that this WILL NOT fit in the original board-game-insert (It will fit inside the outer box). I had to fold/flatten my insert down a bit for it to fit. (Can be seen in photos)
Token organiser pictured above: https://www.printables.com/model/777993-paleo-base-game-token-holder-remix

Andun_HH's Design Allows For Easy Access!

Typical card organizers store the cards very tight and you can't grab the cards in the middle. To avoid this, the slots are alternating up and right.
This allows you to either grab the cards on the right side or lift them up, by pushing down the edge. Just watch the gif and you get the idea. ;)
The slots for the card sets are indicated with the corresponding number on the outside.

boardgame accessories organiser box sorting cardholder paleo paleo boardgame