Aeon's End Insert for Sleeved Cards

UPDATE 8/29/26 : I made another adjustment. I felt the original component trays were a little too tall. I made a v3 tray system. The dice/misc/bottom tray is slightly shorter and now has 3 shorter trays vs 2 "too tall" trays. I reprinted those for myself, but it comes down to preference, so the original files still remain.

UPDATE 7/19/26 : I made a slight adjustment to the mage/nemesis/breach holder to help reinforce the breach holder. Use v2 and v2 spacer if you want an extra wall to help support the inner wall between the breaches and the mages.

UPDATE 7/11/26 : After playing using the insert I realized the 3rd tray, which is extra and is more of a spare tray I don't use, always needed to be removed to get to the bottom characters and nemesis. I now made a new one that uses up the extra height (you don't need the spacer) which can now hold the large spindown dice I made as well as other custom components. But more than that, it was improved that you can get your finger to the bottom and don't need to remove it if you aren't using it...except for storage.

I wanted an insert that accommodates sleeved cards. I saw one insert, but it didn't fit my sleeves. I use Sleeve Kings 8810 (Card Game Sleeves).

I also wanted mid way card stops, so when you take some cards out they all don't slide and fall out of place...give them something to lean against.

Read the file names, print one of each except, 2 card trays (right side) and 3 component trays.

I also included some optional spacers, one to get the component trays to be flush with the top and one to fill in the small gap left next to the components. I print these at 5% infill, skip the bottom and top layers, use cross hatch and it's minimal filament and gets the job done.

Enjoy!

Category: 3D Printing