Above and Below INSERT

for Above and Below (2015) Layer by Layer

Inserts Free

View on MakerWorld 25 112 Added Jun 9, 25 | Updated Sep 13, 26 Support TheVillas by Liking and Boosting their model.

Also Found On Printables 9

Plan Your Print

✓ Fits sleeved cards

About 551 g of filament From the designer's print profile

Print Profile (2) Complete Insert - custom settings (read description) 18h 54m 551 g PLA

Complete Insert - custom settings (read description)

4 plates 18h 54m 551 g PLA

A1, X1, P1P, X1 Carbon, H2D, X1E, P1S, H2D Pro, H2S, P2S, H2C, X2D, A2L

general print settings 0.2mm, 2 walls, 5% gyroid infill except for Frame and Spacer: 0.2mm, 3 walls, 20% gyroid infill

Plate Details (4)

0.4 mm nozzle, all plates

Plate 1

4h 49m 161 g PLA · 161 g

Plate 2

4h 50m 169 g PLA · 169 g

Plate 3

1h 11m 39 g PLA · 39 g

Plate 4

8h 4m 182 g PLA · 182 g

Wider Villager Holders - 0.2mm layer, 2 walls, 10% infill

2 plates 1h 27m 49 g PLA

P1S, H2S, P1P, X1E, X1, H2D, X1 Carbon, A1, H2C, A1 mini, H2D Pro, P2S, X2D, A2L

If you own the French version of Above and Below you may find that the original design of villager holders are not wide enough to allow you to insert all villagers. I created a new version of the starter villager box from scratch, making it slightly wider, with thinner divider walls, and with 4 slots to allow you to separate the starter villager tokens for each player. I also edited the regular/special villager holder to make it slightly wider and reduced the divider wall thickness to allow me to insert all villager tokens, which I could not do with the original version. Both of these still slide into the box with ease and are 100% compatible with the full insert set. I hope this helps.

Plate Details (2)

0.4 mm nozzle, all plates

Plate 1 · Xerses Version - Starting Villagers

52m 29 g PLA · 29 g

Plate 2 · Edited Villagers Holder

35m 20 g PLA · 20 g

As sliced by the designer. Your printer, filament, and settings may change these numbers.

Designer's Description

This is an insert for the Above and Below board game. BASE GAME ONLY.

I know, oldie but goodie. I just got it second hand and it really needed an insert. Hopefully will get some expansions and promos in a near future… But for now, this inserts has:

Card holder: fits sleeved cards, labeled to know where each deck goes.
Villagers storage: one piece for the starting villagers, and another for the special and common villagers.
Coin storage, Resources storage, Dice storage.
Spacers: box is quite big and needed spacers to keep all tidy and help hold the player boards in place. Must print 2 of these.

above below aboveandbelow