Tak Board Game

Tak board carries 60 pieces for playing 6x6 games. The case isn't perfect when closing the case back together but it is good enough. 3mm X 8mm magnets were used for this build. A little super glue before firmly pressing the magnet in will work great. My goal was to make a 6x6 board but taking up the smallest footprint while holding all the pieces to play the game held inside.

I did buy a wooden piece set off of this site. I'm sure you could print your own. I can probably make those if people had enough interest.

My version seen in the photos was printed with wood infused filament to give it that tan wood look. I also used a brown marker to fill in the recessed lines to give it a nice touch. I printed the model with the top of the board faced down (slots are facing the air).

Happy printing!

Caution: Don't put board in the sun and in a warm location for it probably will warp. My first print warped after being in a warm car.