Spirit Island Tokens — Amateur Set (5 pieces)

**Heads up: these are amateur, low-fidelity tokens** made by a hobbyist

learning OpenSCAD. They're functional replacements for the paper

tokens that ship with Spirit Island, but they are NOT polished

display-grade miniatures. Edges are chunky, silhouettes are

simplified, and the art is rough.

If you're OK with that — here's a set of 5:

- **Beast** — coiled serpent on a round yellow pedestal

- **Wilds** — two small fern-frond spirals on a yellow-green rectangle

- **Mountain** — three-peak silhouette on a gray slab

- **Strife** — clenched fist on a blue rectangle

- **Beasts/Paw** — grizzly paw print on a brown rectangle

Each token is two STLs (base + accent) for AMS / dual-filament printing:

assign two filaments per token in Bambu Studio and print flat.

Source is a parametric OpenSCAD .scad per token — sizes, border widths, and accent depths can

all be tweaked before slicing.

The "main" .stl attached to this listing is a small title plaque; the

actual token models are the 10 extra STLs labeled by token name.

- Recommended: PLA or PETG, 0.2 mm layer, 2-3 walls, 15% infill.

- Bed orientation: flat side down (bases have a 0.4 mm chamfer).

- No supports needed.

- Bambu Studio: import a base + accent pair, Assemble, then assign

filament per sub-part. Repeat per token.

- Proportions are eyeballed, not traced from the official art.

- Accent layers are single-height (no embossing detail).

- The Strife fist and the Beasts/Paw are the weakest visually.

- These are fan-made; not affiliated with Greater Than Games.