Kingdom Death Monster Survivor Board with LED

Update: Splitted variant added

This is my Survivor Board which i created as an addition to the gear grid I already created (found here: https://www.thingiverse.com/thing:2812293)
It implements a slot for a DinA5 sheet, a slot for a Pen or Pencil, a slot for the Monster Controler Card and slots for up to 6 Cards (FA, Disorders, whatever you like).
It also has the magnet holes corresponding with the ones from the gear grid.

Additionally and most importantly it also has installed LEDs to indicated the usage of the survival actions. The Shield serves as a pushlever to lit each LED individually. So if only Encourage and Dodge is available you can just lit these two LEDs. If you use a SA during a round just switch it off to show it has been used.
The 4 AA batteries should last at least about 50h possibly even more.
The Icons on the shield represent the survival actions of the base game (except endure which you won't really need) but are exchangeable with different ones (for example replace them with the ones for the people of the sun lantern(not created yet!)). It is a tight fit so that i won't fall out accidently.
The symbols has been adapted from croquetilla croque @ https://boardgamegeek.com/filepage/157961/survival-action-tokens-15
I tried to get in touch with him, but so far no response. I hope he won't mind. Otherwise let me know.

For a full assembly you will need additional components since it implements electronics but the soldering is really easy to do.

16x yellow 3mm LED around 2.2V
example: https://www.amazon.com/Waycreat-750PCS-Emitting-Diffused-Resistor/dp/B06XVL55CY/ref=sr_1_1_sspa?ie=UTF8&qid=1521057575&sr=8-1-spons&keywords=3mm+leds&psc=1

16x 40 - 47 Ohm resistors
example: https://www.amazon.com/Elegoo-Values-Resistor-Assortment-Ohm-1M/dp/B072BL2VX1/ref=sr_1_1_sspa?s=industrial&ie=UTF8&qid=1521057726&sr=1-1-spons&keywords=47+ohm+resistor&psc=1

20 x micro switch lever 9mmx4mmx6mm
like these: https://www.amazon.com/gp/product/B00O9YOEDC/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1

a bunch of these
https://www.ebay.com/itm/10-50-100-Paar-Batterie-Kontakt-Batteriefeder-Metall-Silber-fur-AA-AAA-Batterien/311977427896?hash=item48a34dc3b8:m:mz1AAHhbxzj0wZlJkwsxLqQ

A wiring schematic is added in the files.

also you need wires, AA batteries,a soldering iron and patience :-)

For all other people who just want to print stuff and don't want to do any soldering I also created a board with just sliders which won't need any electronics and additional work. But of course it it not as awesome :-)

Enjoy!!

P.S.: I did not get around to paint it yet (ran out of primer) but i think it will look quite nice. Also don't mind my sloppy soldering. I just learned it by doing^^